Page 1
Installation and Configuration Vigilon BACnet Gateway by Honeywell (VIG-BNG & VIG-BNG-RW) The Vigilon BACnet Gateway (VIG-BNG & VIG-BNG-RW#) provides an interface between a computer network and GENT EN54 Vigilon fire detection and alarm system, using BACnet communication protocol. General Data...
Page 2
Installation and Configuration Vigilon BACnet Gateway How to wire the BACnet Gateway board into the Vigilon Compact Network Node The BACnet Gateway connects to GENT EN54 Vigilon Fire Alarm network via RS232 serial port and connects to BACnet front end via RJ45 Ethernet connector. To wire the BACnet Gateway board inside a Vigilon Network node follow illustrated steps 24V power supply Ethernet RJ45...
Page 3
Vigilon BACnet Gateway Installation and Configuration Connect the BACnet Gateway to a switch/hub. Change the IP address of the network adaptor on you PC to be the same as the Gateway Routing IP address (10.1.6.2). Launch the GENT Configuration tool and make the necessary changes to the GENTGW.ini file. Select the required time zone country / location.
Page 4
Do not burn. Gent by Honeywell reserves the right to revise this publication from time to time and make changes to the content hereof without obligation to notify any person of such revisions of changes.