Transportation, Storage And Disposal - Husqvarna P 520D Operator's Manual

Problem
The cutting result is unsatisfactory
Transportation
• The product is heavy and can cause crush injuries.
Be careful when you load it onto or off a vehicle or
trailer.
• Use an approved trailer for transportation of the
product.
• Make sure that you have knowledge of local road
traffic regulations before transportation of the
product in a trailer or on roads.
To safely attach the product on a trailer for
transport
WARNING: The parking brake is not
sufficient to lock the product during
transport. Attach the product tightly to the
trailer.
Equipment: 2 approved tension belts and 4 wedge
shaped wheel blocks.
1. Apply the parking brake.
2. Attach the tension belts around the frame or rear
wagon.
3. Tighten the tension belts in the direction of the rear
and the front of the trailer to secure the product.
4. Put the wheel blocks in front of and behind the rear
wheels.
To tow the product
The product has a hydrostatic transmission. To prevent
damage to the transmission, tow the product short
distances only and at low speed.
140
Cause
The blades are blunt. Refer to
The grass is long or wet. Refer to
The cutting deck is skew.
There is grass blockage in the cutting deck. Refer to
page 124 .
The tire pressure is different on the right and left sides. Refer to
re on page 132 .
The pivoting wheels have different tire pressure on the right and left sides.
Refer to
The product is operated at a too high speed. Refer to
result on page 122 .
The engine speed is too low. Refer to
The drive belt slips.

Transportation, storage and disposal

To examine the blades on page 133 .
Technical data on page 142 .
Disengage the transmission when you tow. See
release and apply the hydraulic pressure on page 118 .
Storage
Prepare the product for storage at the end of the
season, and before more than 30 days of storage. Tacky
particles from the stored fuel can have a negative effect
on the engine function.
To prevent tacky particles during storage, add a
stabilizer. Add stabilizer to the fuel in the tank or in the
container used for storage. Always use the mixing ratios
given by the manufacturer. Run the engine for a
minimum of 10 minutes after you add the stabilizer until
it flows into the carburetor.
• Clean the product, see
124 . Repair paint damages to prevent corrosion.
• Examine the product for worn or damaged parts and
tighten loose screws and nuts.
• Remove the battery. Clean it, charge it, and keep it
cool during storage.
• Change the engine oil, and discard the waste oil.
To get a good cutting result on page 122 .
To clean the product on
To get a good cutting
Technical data on page 142 .
WARNING: Do not keep the product with
fuel in the tank in an indoor location or in
locations with bad airflow. Risk of fire if fuel
fumes come near open flames and sparks.
WARNING: Remove grass and other
flammable materials from the product to
decrease the risk of fire. Let the product
become cool before you put it in storage.
To clean the product on page
Tire pressu-
To
740 - 002 -