Transportation, Storage And Disposal - Husqvarna TC 112 Operator's Manual

Problem
The cutting result is unsatisfactory.
The blades of the cutting deck does
not start to rotate when the cutting
deck is engaged.
Transportation
• The product is heavy and can cause crush injuries.
Be careful when you load it onto or off a vehicle or
trailer.
• Use an approved trailer for transportation of the
product.
• Make sure that you have knowledge of local
road traffic regulations before transportation of the
product in a trailer or on roads.
• To make it easier to load the product onto a trailer,
put the cutting deck in the highest position.
1903 - 004 - 18.12.2023
Cause
The blades are blunt.
The grass is long or wet.
The cutting deck is not parallel.
There is grass blockage in the cutting
deck.
The air holes in the cutting deck are
clogged.
There is dirt around the blade pul-
leys.
The tire pressure is different on the
right and left sides.
The product is operated at a too high
speed.
The engine speed is too low.
The cutting deck belt slips.
The cutting deck belt is worn or dam-
aged.
There is no grass catcher, or other
accessory, installed to the grass dis-
charge (if applicable).

Transportation, storage and disposal

Action
Examine the blades for wear and
damage. Refer to
blades on page 31 .
Refer to
on page 21 .
Adjust the parallelism of the cutting
deck. Refer to
ism of the cutting deck on page 31 .
Clean the cutting deck. Refer to
clean the cutting deck on page 24 .
Clean the cutting deck. Refer to
clean the cutting deck on page 24 .
Clean the cutting deck. Refer to
clean the cutting deck on page 24 .
Make sure that the tire pressure is
correct in all 4 tires. Refer to
pressure on page 28 .
Refer to
Refer to
Speak to your Husqvarna servicing
dealer.
Replace the cutting deck belt. Refer
To replace the cutting deck belt on
to
page 32 .
Install the grass catcher, or other ac-
cessory, to the grass discharge (if
applicable).
To safely attach the product for transportation
WARNING:
product, you must read and understand the
safety chapter. Refer to
WARNING:
not sufficient to lock the product during
transportation. Attach the product tightly to
the load area.
Equipment: 2 approved straps and 4 chocks.
To examine the
To get a good cutting result
To adjust the parallel-
To
To
To
Tire
Technical data on page 40 .
Technical data on page 40 .
Before you attach the
Safety on page 7 .
The parking brake is
37