Pairing Instructions; Installation - Tripp Lite B164-101-WIR Owner's Manual

Pairing Instructions

1. Power the IR Transmitter and Receiver units using the
2. Press and hold the IR Receiver's LOCK ID button for
3. Once the IR Receiver unit is in pairing mode, press and

Installation

Note: The TX and RX units must be paired before use.
HDMI Display
1. Position the IR Transmitter unit in a place where you
2. Connect the included IR-In cable to the IR Transmitter
3. Place the IR Receiver unit near the IR-enabled equipment
19-01-461-9338E5-EN.indd 5
included USB Power cables.
4 seconds or until the built-in blue IR CON LED begins
to blink.
hold the IR Transmitter's LOCK ID button for 4 seconds
or until the IR Transmitter unit is paired with the IR
Receiver unit.
Note: The blue IR CON LED on the IR Receiver unit will stop
blinking and turn off once the IR Transmitter and Receiver units
have been paired.
IR Input
wish to control your IR-enabled device from up to
656 ft. (200 m) away.
unit.
you wish to control (Blu-ray™, cable box, etc).
Transmitter
(TX)
5
Receiver
(RX)
DVD
IR Output
2/1/2019 10:49:35 AM