Table of Contents
Advertisement
11
12
13
14
15
Locating internal drives
Internal drives are devices that your computer uses to read and store data. You can add drives to your
computer to increase storage capacity and enable your computer to read other types of media. Internal
drives are installed in bays. In this manual, the bays are referred to as bay 1, bay 2, and so on. Your computer
comes with the following factory-installed drives:
• An optical drive in bay 1
• A 3.5-inch hard disk drive or a 2.5-inch solid state disk in bay 3
When installing or replacing an internal drive, it is important to note the type and size of the drive that you can
install or replace in each bay and correctly connect the cables to the drive installed. Refer to the appropriate
section in Chapter 8 "Replacing FRUs (machine types: 10A0, 10A1, 10A6, 10A7, 10AG, 10AK, 10AL, and
10BE)" on page 91 for instructions on how to install or replace internal drives for your computer.
Figure 7 "Drive bay locations" on page 75 shows the locations of the drive bays.
Figure 7. Drive bay locations
1
Bay 1 - Primary optical drive bay (with an optical drive available in some models)
2
Bay 2 - Secondary optical drive bay
3
Bay 3 - Card reader drive bay or mSATA solid-state drive bay
26
27
28
29
.
75
Chapter 7
Locations
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
