Installing The Solid-State Drive - Lenovo 10A4 Hardware Maintenance Manual

Figure 180. Installing the hard disk drive into the bracket
9. Slide the new secondary hard disk drive into the carrier until it snaps into position.
Figure 181. Installing the secondary hard disk drive
10. Connect the signal cable and the power cable to the primary hard disk drive and the new secondary
hard disk drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 224.

Installing the solid-state drive

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Safety information" on page 1.
This section provides instructions on how to install the 2.5-inch solid-state drive.
To install the solid-state drive, do the following:
202
ThinkCentre M83 and M93/p Hardware Maintenance Manual