Installation - Cobra DASH2208 User Manual

SINGLE CAM

INSTALLATION

1
MOUNT
To install the Adhesive Windshield Mount, slide the
dash cam onto the mount and twist to tighten the
cam in desired location. Clean the spot on your
windshield where you would like to mount the
camera and confirm the placement. Reminder, this
is an adhesive mount so it is important to mount
correctly the first time. Next, peel the plastic film off
the 3M adhesive and press the mount FIRMLY onto
the windshield.
2
POWER
Plug one end of the supplied 12V Vehicle Power Adapter into your vehicle's accessory port, and
the other end into the micro USB port. The unit will automatically turn on and start recording.
To manually power on the device PRESS AND HOLD the Power button until the display
activates. When the power button is used to power on the unit recording must be started
manually.
Note: A Hardwire Kit (CA-MicroUSB-001) is available at
installation that allows for discrete routing of the power cable.
3
DRIVE!
Drive HD Dash Cams are designed to set and forget. After initial setup the unit will turn on and
start recording as soon as power is applied. When the Micro SD Card is full the oldest footage
will be deleted to make way for the new. If you witness something that you don't want to be
deleted simply press the Emergency Record button and it will be saved forever.
7 | P a g e
www.cobra.com for a more permanent