FIRST…do not return this product to the retail store. The contact information for Cobra will vary depend- dash cams are the best solution to record your ride. This User Manual covers the SC 200 and SC 200D. ing on the country in which you purchased and utilize the product. For the latest contact information, please go to www.cobra.com/support.
Introduction Installation HARDWARE INTERFACE Reset Button Micro USB Port Power Button (Press and Hold for Power) Event/Emergency USB Power Input Recording Button Video Input SD Card Slot Port for Flex Cam...
Port on the dash cam and run the cable A Hardwire Kit is available at along the floor of your car. Connect the www.cobra.com for a more permanent Extension Cable to the Rear Camera and installation that allows for discrete routing of attach to the vehicle’s back window.
VOICE ANNOUNCEMENTS Your SC 200 will use voice announcements to give you important camera system information when your SD card is full or an impact is detected. INITIAL SETUP When first powered on, the device will show you the video stream and automatically begin loop recording.
VIDEO SCREEN E Indicates whether the microphone is active or muted The Video Screen is the home screen for the device. With the SC 200, based on settings, you can have one view, two views, or three views. F Indicates if Motion Detection is enabled...
Operation Operation VIDEO SETTINGS continued MEMORY CARD STORAGE Loop Clip Time 66% Loop Recording 34% Locked Content This setting allows you to control the duration of each individual movie clip on the device. Video clips can be set to durations of 1 minute, 2 minutes, or 3 minutes. VIDEO AND PHOTO PLAYBACK MODE This device stores video and pictures on its removable SD card.
Date and Time information. must remain on with the ignition off, or the dash cam must be hardwired to a constant power Voice Commands source (please check www.cobra.com for available accessories). Voice Commands can be toggled on/off in this setting. •...
Page 10
Watermark (Date/Time, Speed, GPS, Driver ID Video Stamp Choose between Decimals and Degrees as the GPS format that is stamped in the watermark. The watermark settings allow you to toggle having the date/time, speed, GPS coordinates, the Cobra logo Frequency and a custom Driver ID be stamped into the bottom of all recorded video.
• To check that the Firmware update was successful, you can check the ‘About’ screen in your Optional Flex Cams Include Rear View & In-Cabin Cameras Available for SC 200, SC 200D, SC 400 and SC 400D camera’s settings menu.
NOTES Warranty Terms: Cobra warrants your product against all defects in materials and workmanship for a period of one (1) year from the date of original purchase. Cobra, at our sole discretion, will repair or replace your product (with the same or comparable product) free of charge.