Installation - Hitachi HF-W2000 58 Instruction Manual

1.6.2 Installation

● Use the power cord that comes with this equipment to supply power. Using another power cord
might result in equipment failure, fire, or electric shock. In addition, when using this equipment
at voltages over 125 V AC, prepare a power cord that is compatible with the input voltage to be
used, and perform sufficient testing of equipment operation in advance.
● When plugging the power cord into an outlet, use an outlet with a ground terminal (ground
pole) that is properly grounded. In addition, you must install and use an earth leakage circuit
breaker. Failure to take these measures might result in fire or electric shock.
● Do not use a two-prong plug without a ground pole, because doing so might result in electric
shock or equipment failure.
The equipment might cause injury if it falls or is dropped off of a desktop when placed vertically.
Use the vertical stand provided with the equipment, and place the equipment with the vertical
stand on a level surface.
● Before moving this equipment, shutdown the OS, unplug the power cord, and wait for at least
one minute. Not doing so might cause HDDs, SSDs, and other devices to fail.
● When transporting or carrying the equipment, pack it by using the dedicated container (the
container and packing materials used when the equipment was delivered). Using another
container or other packing materials might damage the equipment.
● Do not use the dedicated container to transport or carry the equipment if the container has
been damaged or broken. Doing so might damage the equipment.
NOTE
• For information about precautions concerning the installation requirements, see (5) Installation environment
under 1. Precautions About the Equipment in PRECAUTIONS.
WARNING
CAUTION
NOTICE
1-13
1. GETTING STARTED