Table 8-9 Error Messages Of The Getrasinfo Command - Hitachi HF-W2000 58 Instruction Manual

Diagnosis
When the getrasinfo command ends normally, it returns exit code 0. When the command terminates with an
error, one of the following error messages appears, and the command returns exit code 1.
Error message
Usage: getrasinfo [/status | /setting]
[/e File]
An error occurred in %s. errorcode=%x
%s: Function name or internal function name of error
Windows API
%x: Error code of Windows API or internal function
You do not have the privilege to run
this command. Please run this command
again on "Administrator: Command
Prompt".
NOTE
• When you run the getrasinfo command, sign in to the computer as an administrator registered on the
computer (as a member of the Administrators group). You cannot run multiple instances of the getrasinfo
command simultaneously.
• Open a command prompt as an administrator to run the command.
• When you are using the /e option, if a file with the same name as the output file already exists at the same
output location, the file is overwritten.
• If the command fails to acquire some of the information required for the output, it is possible that only a section
name appears in a section, or part of the information is replaced with ---. In this case, re-execute the command.
• When a drive is newly connected or replaced during maintenance, recognition of the drive may take some time
upon the first startup after it is connected, and Not Connected might appear for Status of the Drive
condition section. In this case, restart the computer.

Table 8-9 Error messages of the getrasinfo command

There is an error in the specified options. Specify the
options correctly.
An internal error occurred. Re-execute the command.
You do not have administrator privileges.
Sign in to the computer as an administrator, and run
the command again. If User Account Control (UAC) is
enabled, open a command prompt as an administrator,
and then run the command.
8-27
8. MAINTENANCE OPERATIONS
Meaning