Table of Contents
Advertisement
12
www.aeg.com
Step 1
Put the test paper
into water for about
1 sec. Do not put
the test paper under
running water.
The colours of the test paper continue to change. Do not check water hardness later
than 1 min after test.
You can change the water hardness level in the menu: Basic settings / Water hardness.
The table shows water hardness range (dH) with the corresponding level of Calcium
deposit and the water classification. Adjust the water hardness level according to the
table.
Water hardness
Level
1
2
3
4
When the tap water hardness level is 4,
fill the water drawer with still bottled
water.
6. DAILY USE
WARNING!
Refer to Safety chapters.
6.1 Navigating the menus
1. Turn on the oven.
2. Press
option.
3. Press
accept the setting.
Step 2
Shake the test paper
to remove the excess
of water.
Test paper
dH
0 - 7
8 - 14
15 - 21
≥22
or
to select the menu
to move to the submenu or
Step 3
After 1 min, check
water hardness with
the table below.
Calcium de‐
Calcium de‐
posit (mmol/l)
posit (mg/l)
0 - 1.3
1.4 - 2.5
51 - 100
2.6 - 3.8
101 - 150
≥ 3.9
At each point you can go
back to the main menu with
.
6.2 Setting a heating function
1. Turn on the oven.
2. Select the menu: Heating Functions.
3. Press
to confirm.
4. Select a heating function.
5. Press
to confirm.
6. Set the temperature.
Step 4
Set the water hard‐
ness level in the
menu: Basic settings.
Water classi‐
fication
0 - 50
soft
moderately
hard
hard
≥151
very hard
Advertisement
Table of Contents
