Honeywell ESSER IQ8 Operation And Installation Instruction page 31

Operation (green)
LED 1
Lits in normal operation
Common fire alarm (red)
LED 2 Lits when the fire alarm of an assigned wireless device has been detected.
The relay >common fire alarm< is activated.
Common trouble (yellow), display not latched
Lits when a fault message from the IQ8Wireless transponder or an assigned
LED 3
wireless device has been detected. Activation of the >common fault< relay is
interrupted and the relay contact changes position.
Initialisation (yellow)
LED 4
Lits during the switch-on/learning process of the IQ8Wireless transponder while the
wireless devices are being recognised.
Housing screw to open/close the transponder housing
LED-indicators on the board
Status indication of the Analog loop communication
A
Both LED (red and green) twinkle while the data communication on the connected
loop of the FACP IQ8Control is active.
B
red
Off
ON
Flashes alternately
Flashes common
Flashes common
each 7 seconds
FB 798941 / 10.06
IQ8Wireless transponder for wall mounting
LED-incicator for the wireless operation mode
green
Normal operation mode
flashes
All assigned wireless devices operates as required in
(2Hz)
the frequenzy-hopping mode.
Normal operation with a communication fault
At least one wireless device is out of the frequenzy-
hopping mode and is automatically searched in the
flashes base channel. This fault is indicated at the FACP
(2Hz)
after approx. 40-60s. If the wireless device could be
automatically found within this time the red LED goes
out.
Installation mode (restricted operation)
e.g. during field strength measurement, transponder
(2Hz) or detector data assignment or while searching a
wireless device.
Malfunction – Wireless mode disabled
Wireless communication not possible
(2Hz)
is defect (return to factory)
Disablement – wireless mode off
The wireless operation mode is automatically
disabled due to no wireless is assigned or present.
transponder
31