Sync Cameras To The Base Station - NETGEAR VueZone User Manual

Sync Cameras to the Base Station

Syncing the cameras establishes communication between the cameras and the base station.

To sync cameras to the base station:
On the base station, make sure that the Internet LED on front is flashing.
1
The flashing Internet LED shows communication with the Internet. If the LED does not
flash, visit
http://support.netgear.com
Place the camera within 12 inches (30.5 cm) of the base station.
2
Press and release the Sync button on the top of the base station.
3
The blue Sync LED on the base station lights for 45 seconds.
During this time, slide the camera On/Off switch to the on position (green dot showing).
4
The Sync LED on the front of the camera flashes for 5 seconds to confirm sync.
If the camera Sync LED did not flash within 45 seconds, power off the camera and try Steps
5
3 and 4 again.
Once synced, the camera can be viewed and positioned.
6
For a motion detection camera, each time the power is turned on it takes
Tip:
2 minutes for its motion sensor to warm up and begin operating.

To register your base station:
Locate your VGN number on the base station label.
1
Follow the quick install guide instructions.
2
Visit
3 http://vuezone.com/register
Follow the onscreen instructions.
4
VueZone System
to troubleshoot, or contact VueZone support.
to register.
Getting Started
11