Reinstalling The Hard Disk Units - Fujitsu PRIMERGY PG-R1CK2 User Manual

10

Reinstalling the hard disk units

1
Reinstall the hard disk units.
With the plastic lever open, insert
each hard disk unit into their respec-
tive 3.5-inch storage bay as shown in
the diagram below.
2
Snap the plastic lever back into place.
Make sure to snap the plastic lever close of each hard disk to secure them into place.
3
Remove the gasket put on the hard disk unit bay cover.
4
Close the hard disk unit cover.
Attach the hard disk unit bay cover by inserting the two hinges of the cover into their
respective slots located at the front lower left and right corners
Be sure to reinstall the hard disk units back to their correct bays
from which they were removed (refer to "3 Removing hard disk
units" (pg 6)).
Hard disk unit bay cover
10 Reinstalling the hard disk units
Hard disk unit
Shield gasket
Plastic lever
E
21