Controls & Components - Grizzly G0939 Owner's Manual

Controls &
Components
To reduce your risk of
serious injury, read this
entire
using machine.
Refer to Figures 1–3 and the following descrip-
tions to become familiar with the basic controls of
this machine.
B
A
Figure 1. ON/OFF switch and reset button.
A. ON/OFF Switch: Turns motor ON when
moved up; turns motor OFF when moved
down.
B. Reset Button: Allows machine to be restarted
after thermal overload protection has tripped.
To reset, place ON/OFF switch in OFF posi-
tion, wait a few minutes for motor to cool,
then press reset button. If button does not
stay depressed, allow motor to cool longer,
then try again.
C. ON/OFF Switch Disabling Key: Disables
switch when yellow key is removed to prevent
unauthorized operation of planer.
D. Depth-of-Cut Gauge: Shows depth of cut
(from 0"– ⁄ ") when workpiece contacts
1
8
indicator at bottom of gauge.
-4-
manual BEFORE
C
D
E
Figure 2. Elevation controls and return rollers.
E. Return Rollers: Assist sliding workpiece
back to operator following planing operation.
F. Cutterhead Elevation Crank: Raises and
lowers cutterhead. Rotate clockwise to raise
cutterhead; rotate counterclockwise to lower
it. Each full rotation changes elevation
G
Figure 3. Depth stop dial and elevation scale.
G. Cutterhead Elevation Scale: Shows eleva-
tion of cutterhead above table. The measure-
ment indicated along top edge of red indica-
tor shows effective thickness of board after
planing.
H. Cutterhead Depth Stop Dial: Allows opera-
tor to pre-set desired finished workpiece
thickness from ⁄ "–1
1
8
Model G0939/G0940 (Mfd. Since 12/20)
F
⁄ ".
1
16
H
⁄ " (G0940 Only).
1
4