Table of Contents
Advertisement
1070080078 / 03
BT 6.00
Maintenance
5.2
Fusing
5.3
BT 6 Firmware version
5.3.1
Display firmware version
The BT 6 is equipped with a self-regenerating semiconductor fuse.
Therefore, the fuse need not be replaced after a trip.
If the fuse was tripped, proceed as follows:
L
1. Disconnect the unit from power for at least 20 seconds.
2. Reapply the power.
Communication with the weld timer is automatically resumed.
The BT 6 has an integrated microprocessor with an operating program
(firmware) that is stored in an 1 MByte flash memory.
Upon delivery, the most current firmware is installed on the BT 6. When
the power supply is switched on, BT 6 will display the firmware version
for approx. 2 seconds.
Normally, updates are not necessary.
You may display the firmware version if the BT 6 is switched on and prop-
erly connected to the weld timer.
Proceed as follows:
L
1. Press
key.
2. Move the cursor to the "SETUP BT" line with the keys
3. Press
key.
Line 2: Type of BT 6
Line 3: Firmware version
Line 4: Firmware date
Press the
key in order to return to the highest menu level.
L
You may also use Quick Mode and parameter number 92 in order to
.
call up the firmware version (steps 1. to 3.).
For more information on Quick Mode, refer to page 4−7.
Electric Drives
Bosch Rexroth AG
and Controls
(e.g. "BT 6.00")
(e.g. "1070 920852−101")
(e.g. "26.06.2000")
5−3
or
.
Hide quick links:
Advertisement
Table of Contents
