Maintenance, Repair - Bosch Rexroth PS5000 Comissioning, Operating Instructions

1070080078 / 03 BT 6.00
Safety Instructions
1.10

Maintenance, repair

DANGEROUS ELECTRICAL VOLTAGE
Unless described otherwise, maintenance works must be
performed on inactive systems that have been sufficiently
protected against reclosing!
Measuring or test activities that might be necessary on the live
system are reserved to qualified electrical personnel!
DANGER
Lithium batteries may cause causticization or explode if not han-
dled properly!
Therefore, do not open batteries by force, do not recharge or heat
them above 100 degrees Centigrade!
CAUTION
Only spare parts approved by us may be used!
Only use original replacement batteries ! In any case, spent batter-
ies and accumulators should be disposed of as hazardous waste!
CAUTION
Observe all precautions for ESD protection when handling mod-
ules and components! Avoid electrostatic discharge!
The following protective measures must be observed for modules and
components sensitive to electrostatic discharge (ESD)!
D Personnel responsible for storage, transport, and handling must have
training in ESD protection.
D ESD-sensitive components must be stored and transported in the
prescribed protective packaging.
D ESD-sensitive components may only be handled at special ESD-
workplaces.
D Personnel, working surfaces, as well as all equipment and tools
which may come into contact with ESD-sensitive components must
have the same potential (e.g. by grounding).
D Wear an approved grounding bracelet. The grounding bracelet must
be connected with the working surface through a cable with an inte-
grated 1 MW resistor.
D ESD-sensitive components may by no means come into contact with
chargeable objects, including most plastic materials.
D When ESD-sensitive components are installed in or removed from
equipment, the equipment must be de-energized.
Electric Drives Bosch Rexroth AG
and Controls
1−11