Replacement Possibilities - Honeywell krom schroeder IFD 258 Manual

5

Replacement possibilities

The new automatic burner control unit IFD 258 is inter-
changeable with the IFS 258 and provides almost all of the
previous functions of the IFS 258.
The housing dimensions and hole pattern are un- changed.
Signalling contact for fault and operating signals
Flame signal called up via test jacks in upper section of housing using
Complies with requirements in accordance with EN 1993
No protection against frequent switch-off during t
IFD 258 · Edition 03.12l
D-49018 Osnabrü ck, Germany
IFS 258
50/60 Hz
-20/+60 C
CE-0063AT1088
ts
IP 40 (30)
external measuring instrument
Fault signal with no mains voltage supplied
Flame simulation indicated by yellow LED
Operation indicated by yellow and green LEDs
Mains voltage = 100, 115, 200, 230 V
No protection against frequent remote resets
44 ซ.บรมราชชนนี 70 ถ.บรมราชชนนี ศาลาธรรมสพน์ ทวี ว ั ฒ นา กทม. 10170.
website: https://www.add-furnace.com/
Line ID: @add11 e-mail: add028883472@gmail.com
The new upper section of the housing will fit on the existing
lower section (for further information see op- erating
instructions "Automatic burner control unit for continuous
operation IFD 258").
IFS 258 IFD 258
D-49018 Osnabrück, Germany
IFD 258
VAC
CE-0063BXXXXX
Signalling contact for fault and operating signals
The flame signal can be called up on the 2-digit 7-segment display.
Complies with requirements in accordance with EN 2003
Fault signal with mains voltage supplied
Flame simulation indicated on 7-segment display =
Operation indicated on 7-segment display =
Mains voltage = 100, 120, 200, 230 V
Protection against frequent remote resets (blinking
Protection against frequent switch-off during t
SA
IP 54/NEMA 3
01
04
10
(blinking
SA
โทร: 02-888-3472
)
09
)
24