Operation - Makita TD090D Instruction Manual

Installing or removing driver bit or
socket bit
► Fig.5
Use only bits that has inserting portion shown in the
figure.
For European and North & South
American countries, Australia and
New Zealand
A=12 mm Use only these type of bit. Follow the
procedure (1).
B=9 mm
(Note) Bit-piece is not necessary.
For other countries
To install these types of bits, follow
A=17 mm
the procedure (1).
B=14 mm
(Note) Makita bits are these types.
To install these types of bits, follow
A=12 mm
the procedure (2).
B=9 mm
(Note) Bit-piece is necessary for
installing the bit.
1. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit into the sleeve as far
as it will go. Then release the sleeve to secure the
bit.
► Fig.6: 1. Bit 2. Sleeve
2. To install the bit, pull the sleeve in the direction of
the arrow and insert the bit-piece and bit into the
sleeve as far as it will go. The bit-piece should be
inserted into the sleeve with its pointed end facing
in. Then release the sleeve to secure the bit.
► Fig.7: 1. Bit 2. Bit-piece 3. Sleeve
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
• If the bit is not inserted deep enough into the
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.

OPERATION

► Fig.8
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between fas-
tening torque and fastening time is shown in the figures.
Standard bolt
N . m
(kgf.cm)
80
(816)
60
(612)
40
(408)
20
(204)
0
Fastening time
High tensile bolt
N . m
(kgf.cm)
80
(816)
60
(612)
40
(408)
20
(204)
0
Fastening time
Hold the tool firmly and place the point of the driver bit
in the screw head. Apply forward pressure to the tool to
the extent that the bit will not slip off the screw and turn
the tool on to start operation.
7 ENGLISH
M12
M10
M12
M10
M8
M8
(S)
1.0 2.0 3.0
M10
M10
M8
M8
1.0 2.0 3.0 (S)