Install The Hood (Ez1 Brackets) - Kenmore 233.5128 Series Use & Care / Installation Manual

Hide thumbs

Table of Contents

Available languages

NOTE: The following procedure applies to both

framed or frameless cabinet installations.

1. Run house power cable between service panel and

hood location.

2. There are 2 pairs of recessed holes on each side of the

top of the hood (on rear: A and B, on front C and D on

illustration below); these holes allow the range hood to

hang on the brackets (previously installed).

HORIZONTAL EXHAUST INSTALLATION ONLY

3. Temporarily hang the hood on the brackets using its

2 recessed REAR HOLES (A and B). While holding the

hood, run the house power cable into the hood through

the strain relief previously installed

4. Unhook the rear holes from the brackets and hang the

hood using its 2 recessed FRONT HOLES (C and D).

While holding the hood, attach the power cable to the

hood using the strain

VERTICAL EXHAUST INSTALLATION ONLY

5. Hang the hood on the brackets using the 2 recessed

FRONT HOLES (C and D). While holding the hood, run

the house power cable into the hood through the strain

relief previously installed in step 5 on page 8. Attach

power cable to the hood.

6. Connect the ductwork to the hood and use metal foil duct tape to make joints secure and air-tight. Make sure the

damper assembly (or round duct plate) enters the ductwork and that the damper opens and closes freely.

7. For framed cabinet, secure the hood to the EZ1 brackets

using 4 no. 8-18 x 1/2" metal screws (screws included in

parts bag).

Insert 2 screws per side, in the slots

(as shown in inset on illustration beside).

8. For frameless cabinet, secure the hood to the cabinet

using 4 no. 8 x 5/8" round head wood screws (screws

included in parts bag). Insert 2 screws per side, in the

slots (as shown in inset on illustration beside).