Makita CG100D Instruction Manual page 8

For 600 ml size holder
1 2
► 1 . Screw 2. Plate 3. Holder joint
For 800 ml size holder
1
► 1 . Screw 2. Holder joint and plate
Selecting the type of piston
Select the proper type of piston according to the caulk-
ing material container by referring to the following table.
600 ml size
holder
Cartridge Piston A
Film package Piston B
Direct filling Piston C
*. Optional accessary
Installing or removing the rod and
piston
1.
Insert the rod from the rear side of the tool with its
teeth facing down.
3
2
800 ml size
holder
Piston D
Piston E *
-
► 1 . Long rod or black rod
NOTICE:
For 600 ml size holder, use the long
rod. For 800 ml size holder, use the black rod.
2. Attach the piston with the screw.
1 2
► 1 . Screw 2. Piston 3. Long rod or black rod
To remove the rod and piston, follow the installation
procedure in reverse.
Installing or removing 600 ml or 800
ml size holder
CAUTION:
Secure the holder to the holder
joint firmly. Otherwise the holder may come off
during operation and may cause an injury.
To install the holder, turn it clockwise firmly until it stops
while holding the holder joint.
► 1 . Holder
To remove the holder, follow the installation procedure in reverse.
8 ENGLISH
1
3
1