Makita CG100D Instruction Manual page 10

► 1 . Holder
3. Attach the holder cap by turning it firmly while
holding the holder.
1 2
► 1 . Holder cap 2. Holder
4. Push the rod gently until the piston touches the
bottom of cartridge.
To remove the cartridge, follow the installation proce-
dure in reverse.
Using film type package
Preparing package for use
Cut off the tip of the package.
NOTICE:
Be sure to check the package for dam-
age before installation. Using the damaged pack-
age may cause malfunction.
1
Installing film type package to 600 ml
or 800 ml size holder
NOTICE:
Make sure that piston B (for 600 ml
size holder) or piston E (for 800 ml size holder) is
attached to the rod. Do not use other type of pis-
ton for film type package.
1. Remove the holder cap, nozzle, and rubber ring
from the holder.
1 2 3
► 1 . Holder cap 2. Nozzle 3. Rubber ring 4. Holder
2. Pull the rod handle backward slowly until it stops.
3. Insert the package into the holder.
► 1 . Holder
4.
Attach the rubber ring, nozzle, and holder cap by
turning the holder cap firmly.
1 2 3
► 1 . Holder cap 2. Nozzle 3. Rubber ring 4. Holder
5. Push the rod gently until the piston touches the
package.
10 ENGLISH
4
1
4