D-Link SECURICAM Network DCS-2100+ Manual page 30

Using & Configuring the DCS-2100+ with a
NAT Router (continued)
These are the port
settings for your camera.
If necessary, these ports
can be changed if they
are already in use by other
devices (e.g. in a multiple
camera environment).
Router Set-Up and Installation
The following steps generally apply to any router that you have on your network.
The D-Link DI-614+ is used as an example to clarify the configuration process.
Configure the initial settings of the DI-614+ by following the steps outlined in the
DI-614+ Quick Installation Guide.
Access Your Router on Your Web Browser
If you have cable or DSL Internet service, you will most likely have a dynamically
assigned WAN IP Address. 'Dynamic' means that your router's WAN IP address
can change from time to time depending on your ISP. A dynamic WAN IP Address
identifies your router on the public network and allows it to access the Internet.
http://afreelist.com/~bar/pictures/view/1469614/To find out what your router's
WAN IP Address is, go to the Status menu on your router and locate the WAN
information for your router (as shown on the next page). The WAN IP Address
will be listed. This will be the address that you will need to type in your Web
browser to view your camera over the Internet.
Ports that are used by the DCS-2100+
30