Cisco C190 Quick Start Manual page 5

Install the Appliance in a Rack
Appliance Placement in a Rack
Plug In the Appliance
Temporarily Change Your IP Address for Remotes
Access
Install the Cisco C190 Email Security Appliance using the rails supplied. For
information about these installation options, see the Cisco x90 Series Content
Security Appliances Installation and Maintenance Guide.
Ambient Temperature—To prevent the appliance from overheating, do not
•
operate it in an area that exceeds an ambient temperature of 104°F (40°C).
Air Flow—Be sure that there is adequate air flow around the appliance.
•
Mechanical Loading—Be sure that the appliance is level and stable to avoid
•
any hazardous conditions.
Plug the female end of the power cable into the power supply on the back panel
of the appliance. Plug the male end into an electrical outlet.
To remotely configure the Cisco C190 using the network connection, you must
temporarily change the IP address of your computer. Alternatively, you can use
the serial console to configure the Cisco C190, without changing the IP address.
If you use the serial console, proceed to section 8 below.
Make a note of your current IP configuration settings because you will
Note
need to revert to these settings after you finish the configuration.
5