Makita EA3500S Operator's And Safety Manual page 8

Important adjustments
WARNING!
At correct idle speed, chain should not turn. For
directions to adjust idle speed, see the appropriate
section of this operator's manual.
Do not use a saw with incorrect idle speed adjust-
ment. Adjust the idle speed yourself according to
the appropriate section of this manual.
Have your MAKITA dealer check your saw and
make proper adjustments or repairs.
Check the saw chain tension frequently, especially
just after installing a new chain. New chains may
stretch more during their initial use. A properly
adjusted saw chain can be pulled freely around the
guide bar by hand without sagging. Always stop the
engine and wear gloves when checking or ad justing
the chain tension.
Working conditions
Operate your chain saw only outdoors. Operate the saw
under good visibility and daylight conditions only.
WARNING!
Take extreme care in wet and freezing weather
(rain, snow, ice). Put off the work when the weather
is windy, stormy or rainfall is heavy. Clear the area
where you are working.
WARNING!
Avoid stumbling on obstacles such as stumps,
roots or rocks and watch out for holes or ditches.
Be extremely cautious when working on slopes
or uneven ground. There is increased danger of
slipping on freshly debarked logs.
Cutting instructions
Always hold the saw firmly with both hands when the
engine is running. Place your left hand on the tubular
handle and your right hand on grip and throttle lever.
Left-handers should follow these instructions too.
8
Wrap your fingers tightly around the handles, keeping
the handles cradled between your thumb and forefinger
(fig. 7). With your hands in this position, you can best
oppose and absorb the push, pull and kickback forces
of your saw without having it slip out of your grip (see
section of reactive forces).
Make sure your chain saw handle and grip are in good
condition and free of moisture, pitch, oil or grease.
Always start a cut with the chain running at full speed
and the spike bar in contact with the wood.
When starting a cut, the blade can slip to the side
or jump slightly. This depends on the wood and the
condition of the chain. Therefore, always hold the
chain saw with both hands.
Never use the saw with one hand. You cannot
control reactive forces (see pages 9 to 11) and
may lose control of the saw.
Do not operate your chain saw in semi-throttle
position. Cutting in this position does not permit the
operator proper control of the saw or chain speed.
Never come too close to a rotating chain with your
hands or body.
Cut wood only. Do not use the chain saw for
purposes not intended. For example: do not use
the chain saw for cutting plastic, masonry, or
non-wood building materials.
Use your chain saw for cutting only. It is not
designed for prying or shoveling away limbs, roots
or other objects.
When sawing, make sure that the saw chain does
not touch any foreign materials such as rocks, nails
and the like (fig. 8). Such objects may be flung off,
damage the saw chain or cause the saw to
kickback.
If the chain saw is exposed to force, such as
through impact or falling, inspect the entire chain
saw for proper functioning.
7
WARNING!
WARNING!
WARNING!
WARNING!
8