Cleaning The Door; Error Code Failure System - Baumatic BDWS59SS User Manual

Cleaning the door

o DO NOT use any abrasive cleaner or scouring pads on the inner
or outer surfaces, as they may cause damage to them.

Error code failure system

The following error codes can possibly be remedied by the customer
and the maintenance steps outlined below should be followed.
BEFORE COMPLETING
APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR MAINS
POWER SUPPLY.
E-2
o Longer than expected fill time.
 Check the water pressure of your mains water supply.
 Clean the mesh filter that sits in the inlet hose.
 Ensure that the inlet hose is not kinked or crushed.
 Make sure the water tap that the machine is connected to is
turned on fully.
E-3
o Longer or extended drain time.
 The drain pipe may be placed in too high a position or
incorrectly. Check the installation instructions and ensure that
the installation is correct.
 Check that the outlet hose is not kinked or crushed.
 Make sure that the drain hose has not been extended beyond its
original length.
E-3
The machine has sensed water in the base.
 Check that the outlet hose is not kinked or crushed.
 Check that there are no blockages in the drain hose or the
drainage system that the appliance is connected to.
 The drain pipe may be placed in too high a position or
incorrectly. Check the installation instructions and ensure that
the installation is correct.
27
o To clean the edge around the outside of
the door, you should use a soft, damp
cloth only.
o To prevent water from penetrating the
door lock or electrical components, DO
NOT use a spray cleaner of any kind.
ANY MAINTAINEANCE ON THE