Table of Contents
Advertisement
Vitroceramic Heating elements
Electrical plates
(Figg. 2-3-1a-1b). Rotate the knob towards the position required for cooking and bear
in mind that the higher the number, the higher the heat output. See table "use of
electrical plates".
The pilot light on the stove panel level signals that the plate is "on".
Some types of pilot lights will maintain some slight luminescence even after
disconnection. That is quite normal.
N.B.: When using electrical elements/plates, we recommend flat bottom recipients
with a diameter equal or slightly larger than that of the plate itself.
• avoid liquid overflow. Therefore, after boiling or heating liquids, reduce the heat
output;
• do not leave the electrical elements/plates on with empty pots and pans;
• when cooking is finished, rotate the knob back into closing and/or disconnected
position.
In the event of even a slight fracture on the cooking vitroceramic surface, disconnect
the electric power supply immediately.
Maintenance
Gas/Electric
Prior to any operation, disconnect the appliance from the electrical system.
For long-life to the equipment, a general cleaning operation must take place
periodically, bearing in mind the following:
• the glass, steel and/or enamelled parts must be cleaned with suitable non-abrasive or
SWITCHED OFF
Fig. 2
ELECTRIC
PLATES
VITROCERAMIC HEATING ELEMENTS
Fig. 3
6
Advertisement
Table of Contents
