Specifying Welding Conditions (Material/Wire Diameter/Gas And Pulse) - Panasonic YD-400VP1YHD Operating Instructions Manual

7.1.2 Specifying welding conditions
(material/wire diameter/gas and
pulse)
Dial 1
1． Select a mode.
Press mode SELECT button several times
until LED for WELD lis lit.
The LEDs of the current welding condi-
tions (material, wire diameter and weld-
ing process) or default settings are lit (or
blink).
2． Specify welding conditions (Material, Wire diameter, Gas and Pulse.
Select a material, wire diameter and gas
Press any one of MATERIAL, WIRE DIA.,
GAS select buttons, then all 3 lighted
LEDs turns blinking.
→ While LEDs are blinking, the welding
power source is searching the welding
table of the combination.
(Example of welding conditions: Mild
steel, 1.0 mm (in dia.) and CO
WMD078TE0PAA07
Display1 Display2
ENTER Dial 2
gas.)
2
Material/Wire diameter/Gas
Panasonic
VP1 series
MODE SELECT button
Current welding conditions.
All 3 LEDs blink
7. Welding operation
LCD
PULSE button
(No indication)
(No indication)
WELDING DURING
DATA RETRIEVAL
63