PARKZONE Radian Pro DX7 Setup Instructions

With the DX7 you can take full advantage of the possible mixing options on the Radian Pro.
This setup allows for CROW, camber and reflex, and normal flaps to be programmed into the
radio.
The setup listed has the flaps operated by the AUX 2 switch on the DX7. The 3-position flaps
switch controls the camber and reflex and the gear switch activates the CROW.
This setup uses a 6 channel receiver. If a 7 channel receiver is used, for the mixing to work
correctly, the flaps must use the Y-Harness.
CAUTION: When setting up the airplane with the airplane turned on, it
is advisable to unplug the motor or remove the propeller to prevent the
motor from accidentally going to full throttle, if throttle is selected when
Adjust the travel adjust on the gear so when the gear switch is in the up position the flaps are
even with the trailing edge of the wing. When the gear switch is moved to the down position,
set the value to give the amount of flap throw listed in the manual.
1. Go to the FLAP SYS menu
2. Set the NORM to U 20%
3. Set MID to 0%
4. Set LAND to DN 20%
These values give the amount of up and down aileron when using the camber and
reflex.
Radian Pro DX7/7se Setup
setting up one of the mixes.
Setting up Dual Aileron
In the main setup menu, turn FLAPERON to ON.
Reversing
Throttle: normal
Aileron: reverse
Elevator: reverse
Rudder: reverse
Gear: normal
Flap: reverse
AUX2: normal
Setting up the Flaps on the Gear Channel
Setting up the Aileron for Camber and Reflex