Serial Pass Through Settings - GE SymNet1 User Manual

Chapter 3 27
WebServer

Serial pass through settings

The Serial pass through settings page allows you to use the SymNet1 to pass RS485 commands between
devices such as a KTD keypad and a dome camera. Two SymNet1s are required for this type of setup. One is
set up as a transmitter and the other as a receiver (Figure 17).
In the system described in this section, SymNet1 1 is configured as a receiver for serial pass-through data and
as a sender to stream video to SymNet1 2. SymNet1 2 is configured as a sender for serial pass-through data and
as a receiver for the streaming video for SymNet1 1.
Figure 17. Serial pass thru diagram
ProBridge
SymNet1 1
CyberDome
5
1
3
6
I/O box 1043406
2
7
SymNet1 2
KTD-405 keypad
1
4
CCTV monitor