Troubleshooting - AEG DVD-R 4518 Operation Manual

Troubleshooting

Themen
Troubleshooting
Before sending the machine to the Customer Services, use the following table to check whether you can rectify
the fault yourself.
Fault
Functions - General
WARNING:
Before troubleshooting, switch the player off and remove the mains plug. Wait until the player and accessories have cooled
down. Never use a defective player.
Device not working
No response when
pressing button
Picture
WARNING:
Before troubleshooting, switch the player off and remove the mains plug. Wait until the player and accessories have cooled
down. Never use a defective player.
No image displayed on
screen
The television pictures
are distorted.
The playback picture is
distorted.
The playback picture
is distorted if several
devices are connected.
Sound
No sound
80
05-DVD-R 4518 AEG - GB 80
Possible cause
No power supply
No power supply / switch turned
off
Power supply problem or static
charging of appliance
Video cable not correctly
connected
Poor reception or incorrect
settings
Interference from radio waves
If a DVD recorder, video recorder
or tuner is connected to your
television through the device, the
copy protection signal transmitted
for many programs could be
affecting picture quality.
Audio cable not connected
Amplifi er switched off
System settings incorrect
Solution
Insert the mains plug correctly and check that the socket is
working with another device if necessary.
Turn the device on by the switch (Fig. 1/1 or 3/1).
Disconnect the mains plug. Insert the mains plug into the
socket and switch the player on again.
Check the correct fi t of the Video cable
➯ „Connecting the Video cable".
Make sure that the jacks are tightly in the sockets.
Try turning the television aerial around.
Adjust the picture. (See the operating instructions for the
television set.)
Place the antenna and the television set further apart.
Do not approach the device with equipment which might
cause interference, such as mobile or cordless telephones.
Disconnect the playback devices concerned and connect the
device directly to your television set.
If you do not use a SCART plug for transmission of the video
signal, it is necessary to use an audio cable in addition to the
video cable.
If you use an amplifi er for Audio output: check whether the
amplifi er is switched on.
Check the system settings of the DVD recorder.
05.07.2006, 10:31:41 Uhr