Remote Control Battery Installation; Remote Control Receivers And Operating Range; Wired Remote Control Transmitter - Canon LV-7585 User Manual

Remote Control Battery Installation

Open the battery
1
compartment lid.
Press the lid downward and
slide it.
To insure safe operation, please observe the following precautions :
● Use two (2) AAA or LR03 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control unit to moisture or heat.
● Do not drop the remote control unit.
● If the battery has leaked on the remote control unit, carefully
● Risk of an explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions.

Remote Control Receivers and Operating Range

Point the remote control unit toward the projector (to
Infrared Remote Receivers) when pressing the buttons.
Maximum operating range for the remote control unit is
about 16.4' (5 m) and 60 degrees in front and rear of the
projector.
Infrared Remote Receivers are provided both in front and
back of the projector. You can conveniently use both of
the receivers (pp. 10, 51).

Wired Remote Control Transmitter

The remote control unit can be used as a wired remote control unit.
Wired remote control unit helps you use the remote control unit
outside of the operating range (16.4'/ 5 m). Connect the remote
control unit and the projector with the remote control cable (sold
separately). Connected with the remote control cable, the remote
control unit does not emit wireless signal.
Install new batteries into
2
the compartment.
wipe the case clean and install new batteries.
Part Names and Functions
Replace the
3
compartment lid.
Two AAA size batteries
For correct polarity (+ and –),
be sure battery terminals are
in contact with pins in the
compartment.
16.4'
(5 m)
16.4'
(5 m)
15