Remote Control Unit Battery Installation; Remote Control Unit Operating Range; Remote Control Code - Canon LV-8225 User Manual

Part Names and Functions
Open the battery
1
compartment lid.
WARNING
To ensure safe operation, please observe the following precautions :
● Use two (2) AAA type batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control unit to moisture or heat.
● Do not drop the remote control unit.
● If the battery has leaked on the remote control unit, carefully wipe the case clean and install new batteries.
● Risk of an explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.
Point the remote control unit toward the projector
(Infrared Remote Receiver) when pressing the buttons.
Maximum operating range for the remote control unit is
about 16.4'(5 m) and 60 degrees in front of the projector.
The  different remote control codes (Code 1–Code
) are assigned to this projector. Switching the remote
control codes prevents interference from other remote
control units when several projectors or video equipment
next to each other are operated at the same time.
Change the remote control code for the projector first
before changing that for the remote control unit. See
"Remote control" in the Setting Menu on page 59.
Press and hold the MENU and IMAGE buttons for more
than five seconds to switch between the Code 1 and
Code 2. The initial code is set to Code 1.
14
Remote Control Unit Battery Installation
Install new batteries
2
into the compartment.
Remote Control Unit Operating Range
Remote Control Code
Two AAA size batteries
For correct polarity (+
and –), be sure battery
terminals are in contact
with pins in compartment.
30°
30° Remote control unit
Replace the
3
compartment lid.
16.4'
(5 m)
MENU button
IMAGE button