Rear Terminal - Canon LV-7585 User Manual

Rear Terminal

q
w
e
r
t
q COMPUTER INPUT TERMINAL (DIGITAL)
Connect the computer output digital signal to this
terminal. The HDTV (HDCP compatible) signal can
also be connected (pp.20-21).
✔
Note:
• Use a DVI-Digital cable which fits the width of the rear
terminal.
w COMPUTER INPUT TERMINAL (ANALOG)
Connect the computer (or RGB scart) output signal
to this terminal (pp.20-21).
5 BNC INPUT jACKS
e
Connect the component or composite video output
signal from video equipment to VIDEO/Y, Pb/Cb,
and Pr/Cr jacks or connect the computer output
signal (5 BNC Type [Green, Blue, Red, Horiz. Sync,
and Vert. Sync.]) to G, B, R, H/V, and V jacks (pp.20–
21).
VIDEO INPUT jACK
r
Connect the component or the composite video
output signal from video equipment to this jack
(p.21).
t R/C jACK
When using the wired remote control unit, connect
the wired remote control unit to this jack with a
remote control cable (not supplied).
!0
y
USB CONNECTOR (Series B)
y
Use this connector when controlling a computer
with the remote control unit of the projector.
Connect the USB terminal of your computer to this
connector with the supplied USB cable (p.20).
CONTROL PORT CONNECTOR
u
When controlling the projector from a computer,
connect the computer to this connector with a
control cable (p.20).
i S-VIDEO INPUT jACK
Connect the S-VIDEO output signal from video
equipment to this jack (p.21).
MONITOR OUT TERMINAL
o
This terminal can be used to output the incoming
analog RGB signal from INPUT 1-3 terminal to the
other monitor (pp.20-21).
!0 INFRARED REMOTE RECEIVER (Back)
The infrared remote receiver is also located in the
front (pp.10, 15).
Kensington Security Slot
]
This slot is for a Kensington lock used to deter theft of the
projector.
*Kensington is a registered trademark of ACCO Brands Corporation.
RESET button
[
A built-in micro processor which controls this unit may
occasionally malfunction and need to be reset. This can
be done by pressing the RESET button with a pen, which
will shut down and restart the unit. Do not use the RESET
function excessively.
Part Names and Functions
]
o
[
i
u
11