Buffalo WLA2-G54C Quick Setup Manual page 9

Using AOSS
continued
Note: AOSS mode will stay active for a period of two minutes. This is the time-slot
required to initiate the wireless client adapter.
◗
Refer to your wireless client adapter's AOSS supplement to initiate the
wireless client adapter's AOSS mode.
◗
Once the client adapter has begun communicating with the AOSS router, the
AOSS client will report a successful AOSS connection. This indicates that the
AOSS process has begun and the two devices are configuring themselves.
At this time, the AOSS Light on the WLA2-G54C will become solid. Please
refer to your wireless client adapter's supplement for the remainder of the
setup.
Additional AOSS Information:
◗
Only one AOSS wireless client adapter can be configured to the AOSS
access point at a time. Thus, the button will need to be repressed for each
additional AOSS wireless client adapter that will be connected.
◗
It is not necessary to AOSS client devices that have already been configured
via AOSS, unless significant changes have been made to the wireless
network.
◗
Do not attempt to configure two separate AOSS networks at the same time,
as it may cause undesired configurations.
◗
If an undesired client has connected via AOSS, it can be disconnected from
within the WLA2-G54C's advanced configuration AOSS menus.
◗
Now that the WLA2-G54C and wireless
client adapter are installed, you can use
AOSS to configure them.
◗
To begin the configuration, press the AOSS
button on the side of the WLA2-G54C
chassis until the AOSS LED on the front
begins to flash.
AOSS Mode is now active.
9