Honeywell 11000 Series Manual page 7

5. Install the new filter. Note direction of airflow arrows, if
present. If arrows are not present, install the filter with
the fasteners facing downward.
6. Fasten the filter tabs. Be sure there is a snapping sound
when they are fastened. The tabs are commercial
Velcro and require more force to fasten.
IMPORTANT
Do not touch the pleated filter media. Handle only the
filter frame to prevent damage to the filter media.
7. Close and latch the lid.
CPZ™ Adsorbent Module
The CPZ™ adsorbent module is used to collect gases,
vapors, odors and volatile organic compounds (V.O.C.) from
the air that passes through the air cleaner. Adsorbents collect
and hold 25% to 50% of their weight in odorous gases and
vapors. The impurities are collected until the adsorbents reach
saturation. At saturation, the adsorbents emit a continuous
strong pungent odor. If the air cleaner is turned off for 8 to 10
hours, there will a temporary odor when it is turned back on. If
the odor persists for 30 minutes, it is time to replace the filters.
NOTE: When tobacco smoke is a contaminant, both the
particle filter and the adsorbent filter will need to be
serviced at the same time.
F111 (SERIES 11000) IN CEILING MEDIA AIR CLEANER
1. Slowly open the lid, supporting the lid so the filters do
not fall out.
2. Support the adsorbent module with one hand and
release the fastener.
3. Use two hands and slide the filter from the housing.
IMPORTANT
The module weighs about 26 lb (12 kg) and can be
hard to handle.
4. Place the spent module in a plastic trash bag and
dispose of properly.
5. Remove CPZ™ sorbent modules from their packaging
and install. Be sure the fastener tabs (3) are facing
downward and fastened.
IMPORTANT
Avoid excessive pressure on the individual
adsorbent panels.
6. Close and latch the lid.
NOTE: On initial startup, a small amount of dust can blow
from the air cleaner. This is normal and stops a few
minutes after startup.
7 68-0198EF-2