If You Are Having Difficulty With Your Mfc - Brother MFC-730 Owner's Manual

174
C H A P T E R T W E N T Y
DIFFICULTY
Printing or Receiving Faxes
Condensed Print and Horizontal
Streaks / Top and Bottom of
Sentences Are Cut Off
Poor Quality Print
Printing Too Dark or Too Light
Printing Appears Dirty or Ink Seems
to Run
Replace the multi-purpose sheet feeder.
Paper is jammed inside the back of the MFC.
1
Pull the paper out of the back of the MFC while holding up the
release lever at the rear of the MFC.
2
Close the Top Cover.
3
Replace the multi-purpose sheet feeder.

If You Are Having Difficulty with Your MFC

If you think there is a problem with your MFC, make a copy first. If the
copy looks good, the problem is probably not your MFC. Check the chart
below and follow the troubleshooting tips.
SUGGESTIONS
If your copy looks good, you probably had a bad connection, with
interference on the phone line.
Make sure the Printer Driver matches the type of paper you are using
(see PrintMedia on chap.18). If you are using plain paper, try using
recommended special paper (see Chapter 3). Don't handle the paper
until the ink is dry. Adjust the Vertical Alignment (see chap.18).
Make sure your ink cartridges are fresh and within their expiry dates.
Cartridge expiry dates are printed on the package. Make sure the
Printer Driver matches the type of paper you are using (see Print Media
on chap.18). Try using recommended special paper (see Chapter 3). The
recommended environment for your MFC is between 15 C to 30 C.
Make sure you are using the recommended paper (see Chapter 3).
Don't handle the paper until the ink is dry.The recommended
environment for your MFC is between 15 C to 30 C.
Release Lever (Blue)