Advertisement
Ⅰ－１. SCOPE
This data sheet describes the standard information (not items guaranteed) except
specifications for the detail design and work. Users shall consider the other information．
Ⅰ－２. MECHANICAL CHARACTERISTICS
Cell Type
Front cover material
Encapsulation material
Back cover material
Dimension
Weight (Typical)
Terminal box
Bypass Diode
Cable
Connector
Ⅰ－３. ELECTRICAL CHARACTERISTICS
The initial electrical characteristics at STC (standard test conditions) (Irradiance: 1000
Wm-
with the AM1.5 spectral irradiance distribution, Cell temperature: 25ºC±2ºC) is shown
2
in Table I-1 and the nominal electrical characteristics at STC are shown in Table I-2.
Rated electrical characteristics are within ±10% of the indicated value of Isc, Voc and
+10%/-5% of Pmax (Power measurement tolerance:±3.5%).
The nominal electrical characteristics (Pmax, Voc, Isc, Vmpp, and Impp) are specified based
on the result of the production line test. However, the characteristic of each module measured
by the shipping test varies within tolerance. The warranty conditions are specified in this
manual．
thin-film silicon
(amorphous Si / microcrystalline Si tandem structure)
Low iron non-tempered glass
Black color resin for Photovoltaic
Tempered glass
Length: 1402mm Width: 1001mm Depth: 24mm
26 kg
Material: PPE/PPO resin
One bypass diodes shall be installed in the terminal box
PV1F cable 2.5mm sq. / Length 900mm (Typ.)
JAE Connector
Model No. KB1
IP-rating 67
Ⅰ-２
MTA14005
Advertisement
