Functional Description - Makita 4101RH Instruction Manual

h) Do not restart the cutting operation in the
workpiece. Let the wheel reach full speed and
carefully re-enter the cut. The wheel may bind,
walk up or kickback if the power tool is restarted in
the workpiece.
i) Support panels or any oversized workpiece to
minimize the risk of wheel pinching and
kickback. Large workpieces tend to sag under
their own weight. Supports must be placed under
the workpiece near the line of cut and near the
edge of the workpiece on both sides of the wheel.
j) Use extra caution when making a "pocket
cut" into existing walls or other blind areas.
The protruding wheel may cut gas or water pipes,
electrical wiring or objects that can cause kickback.
17. Before using a segmented diamond wheel,
make sure that the diamond wheel has the
peripheral gap between segments of 10 mm or
less, only with a negative rake angle.
Additional safety warnings:
18. Never attempt to cut with the tool held upside
down in a vise. This can lead to serious
accidents, because it is extremely dangerous.
19. Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
20. Store wheels
recommendations.
damage the wheels.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
as per manufacturer
Improper storage

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Portable residual current device
Fig.1
Connect the tool to a power supply and test the Portable
Residual Current Device (PRCD) before using the tool.
Push the "RESET" or "ON" button and confirm that the
pilot lamp lights. Push the "TEST" button and confirm
that the pilot lamp goes out. Push the "RESET" or "ON"
button again to use the tool.
WARNING:
Do not use the tool if the pilot lamp does not go out
•
when the "TEST" button is pushed.
Adjusting the depth of cut
Fig.2
Loosen the wing bolt on the depth guide and move the
base up or down. At the desired depth of cut, secure the
base by tightening the wing bolt.
CAUTION:
After adjusting the depth of cut, always tighten the
•
may
wing bolt securely.
Adjusting bevel angle
Fig.3
Loosen the wing nut on the bevel scale plate on the front
of the base. Set for the desired angle (0° - 45°) by tilting
accordingly, then tighten the wing nut securely.
Loosen the wing bolt on the depth guide and move the
base so that the end of the blade case is above the red
line on the depth guide. Then tighten the wing bolt to
secure the base.
Fig.4
NOTE:
If the end of the blade case is under the red line on
•
the depth guide, the outer flange may hit the
workpiece when you perform the bevel cut.
Sighting
Fig.5
For straight cuts, align the "A" position on the front of the
base with your cutting line. For 45° bevel cuts, align the
"B" position with it.
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
6