Led Indicators; Safety Warnings - Digicom Pocket GPRS Micro Industrial Quick Manual

Pocket GPRS Micro Industrial

LED INDICATORS

Through two led indicators you can control the status of Pocket GPRS Micro Industrial:
LED STATUS DESCRIPTION
PWR
OFF Device turned OFF
ON Device turned ON
ACT
OFF SIM card not present or PIN not inserted or GSM Network
Searching or Low GSM Signal Level
Blinking Good GSM Signal Level
ON Excellent GSM Signal Level
All rights reserved; no part of this publication may be reproduced, stored in a retrieval system, or trasmitted in any form or by any means, electronic, otherwise,
without the prior written permission of Digicom S.p.A. The contents of this booklet may be modified without notice. Every possible care has been taken in testing
and putting together all the documentation contained in this booklet, however Digicom S.p.A. can not take any responsability brought by the use of this booklet.
PREFACE
In order to guarantee your safety and a correct functioning, be sure to follow these safety warnings. The whole set (with cables
included) must be installed in a place lacking of or distant from:
• Dust, humidity, high temperatures and direct exposure to sunlight.
• Heat irradiating objects, which may damage your device or cause any other problem.
• Objects producing a high electromagnetic field (Hi-Fi speakers, etc.).
• Corrosive liquids or chemical substances.
ENVIRONMENTAL CONDITIONS
Environment temperature: from -20 °C to +55 °C Relative humidity: from 20 to 80 % n.c.
CLEANING INFORMATION: Use a soft dry cloth and avoid any solvents or abrasive materials.
SHOCKS OR VIBRATIONS: Caution against shocks or vibrations.

SAFETY WARNINGS

Read these instructions and norms carefully before powering the device. Violation of such norms may be illegal and cause hazard
situations. For any of the described situations please refer to the specific instructions and norms.
The device is a low power radio transmitter and receiver. When it is ON, it sends and receives radio frequency (RF) signals.
The device produces magnetic fields. Do not place it next to magnetic supports such as floppy disks, tapes, etc.
Operating your device close to other electrical and electronic equipment - such as a television, phone, radio or a personal
computer - may cause interferences.
INTERFERENCES
The device, like all other wireless devices, is subject to interferences that may reduce its performances.
ROAD SAFETY
Do not use your device while driving. In case of use on cars, you must check that the electronic equipment is shielded against RF
signals. Do not place the device in the air bag deployment area.
AIRCRAFT SAFETY
Switch off your device when on board aircrafts by disconnecting the power supply and deactivating the internal backup battery.
Using GSM devices on aircrafts is illegal.
HOSPITAL SAFETY
Do not use the device near health equipment, especially pacemakers and hearing aids, in order to avoid potential interferences.
Take care when utilizing the device inside hospitals and medical centres, which make use of equipment that could be sensitive to
external RF signals. Switch it off when use is expressly forbidden.
EXPLOSIVE MATERIALS
Do not use the device in refuelling points, near fuel or chemicals. Do not use the device where blasting is in progress. Observe
restrictions and follow any specific regulation or instruction.
Quick Guide
ENG.3