Troubleshooting - Breville AirRounder Plus Connect Instruction Book

Troubleshooting

MINI TROUBLESHOOTING GUIDE
Before carrying out any of the following service checks, unplug the unit from the mains.
PROBLEM
Unit will not start
Insufficient air flow
Excessive noise
Light ring not illuminating
Not heating in the heating mode
Poor air purification quality
Filter Indicator is still
illuminated after replacing the
air filter
PM2.5 value of the display is
seriously high or it does not
drop from a higher value
If the problem is not listed, please contact Breville Customer Service Centre (see back cover for contact details).
LPH708_ANZ_IB_B21_FA.indd 21 LPH708_ANZ_IB_B21_FA.indd 21
WHAT TO DO
•
Check that the power plug is connected to a power outlet and the
outlet is turned on.
•
Check that purifier fan heater is assembled correctly.
•
Check that the filter is fitted correctly in place.
•
Make sure the filter is removed from the packaging.
•
Check that the filters are clean.
•
Check for any obstructions in the air inlet and/or outlet.
•
Check if the filter is clogged and ready for replacement.
•
Check that the rear housing cover is closed properly.
•
Check that the unit is on a level surface.
•
Contact Breville service centre for replacement.
•
Check for any obstructions in the air inlet and/or outlet.
•
Surface temperature of the heating plate rises, and the thermostat
has stopped working.
•
Clean the air quality sensor (see page 18).
•
Reset the REPLACE FILTER indicator (see page 19).
•
Air quality sensor mesh filter needs to be cleaned.
21
29/1/21 11:04 am 29/1/21 11:04 am