Breville AirRounder Plus Connect Instruction Book page 13

MEMORY
The purifier fan heater has a memory function
and will return to the last setting it was set to
when it was turned off. This will only occur if
the purifier fan heater is not unplugged and/or
switched off at the power point.
FUNCTIONS
Cooling Mode
Your purifier fan heater has 3 cooling fan
settings: LOW, MEDIUM and HIGH.
5. To choose between these cooling fan
settings, press the
control panel or
remote control, until the desired setting
illuminates on the LED display screen.
The LED display screen will display the
room ambient temperature and current
fan setting.
6. To cancel a cooling setting, press the
button to stop operation.
If the operation is stopped, the unit will enter
standby mode and the LED display screen
will be dimmed and display the ambient room
temperature.
Heating Mode
Your purifier fan heater has 3 heat settings:
LOW, MEDIUM and HIGH and allows you to
set your desired temperature.
1. To choose between these heat settings,
press the button found on the control
panel or press the
remote control repeatedly, until the desired
setting illuminates on the control panel
LED lights. The LED display screen will
illuminate the room ambient temperature
and the light ring will illuminate red.
2. To cancel a heat setting, touch/press the
button on the control panel or remote
control to stop operation. If the operation
is stopped, the unit will enter standby mode
and the LED display screen will illuminate
'OFF' whilst the unit is cooling down. Once
cooled, the ambient room temperature will
be displayed.
LPH708_ANZ_IB_B21_FA.indd 13 LPH708_ANZ_IB_B21_FA.indd 13
button found on the
button found on the
button found on the
WARNING
To avoid overheating, do not cover the heater.
Set Temp
Take control of your room temperature.
Everyone's comfort levels are different, so you
can set your own preferred temperature or even
heat the room before you go to bed.
1. To set the desired temperature, touch and
hold for 3 seconds the
on the control panel or press and hold
for 3 seconds the button found on the
remote-control.
2. To increase the temperature tap the
button on the control panel repeatedly
or press the button repeatedly on the
remote control.
3. To decrease the temperature, tap the
button on the control panel repeatedly
or press the button repeatedly on the
remote control.
4. Once the temperature has been set, the
LED display screen will illuminate the
room ambient temperature. The purifier
fan heater will maintain the room ambient
temperature to the temperature setting
automatically.
NOTE
Choose the heat setting to determine how
quickly the purifier fan heater will maintain the
set temperature setting.
NOTE
When the purifier fan heater is turned on from
standby, the memory function will start heating
based on the previously set temperature and
heating setting.
NOTE
When operating the purifier fan heater
remotely in heat mode, the purifier fan
heater will automatically switch off after
7hrs by default.
button found
13
29/1/21 11:04 am 29/1/21 11:04 am