Table of Contents
Advertisement
Once the machine has been plugged back into your mains power
supply, to clear the fault code from the LCD display, you should turn
on the machine and hold down the Start/Stop button for approximately
5 seconds.
o The washing machine is overloaded.
Clean the pump filter.
Reduce the wash load.
o No water in the washing machine.
Make sure the water tap that the
machine is connected to is turned on
fully.
Clean the mesh filter that sits in the
inlet hose.
o The water was not pumped out.
Clean the drain pump filter.
Check the drain hose is not blocked
or kinked.
o The appliance has recognised a
foam surplus, therefore the wash
cycle completes without spin
To get the soap suds out of the
clothes, the rinses and conditioning
program should be selected. Do not
put any detergent in the machine
for this wash cyc
ning.
le.
23
Advertisement
Table of Contents
