Troubleshooting - D-Link NUCLIAS CONNECT DAP-3666 User Manual

Troubleshooting

Troubleshooting
This chapter provides solutions to problems that can occur during the installation and operation of the DAP-3666. We will cover various aspects
of the network setup, especially the network adapters. Please read the following if you are having any technical difficulties.
Note: It is recommended that you use an Ethernet connection to configure the DAP-3666.
The computer used to configure the DAP-3666 cannot access the Configuration menu.
y Check if the Power LED on the DAP-3666 is ON. If the LED is not ON, check if the cable for the Ethernet connection is securely inserted.
Note: The default LAN settings for the DAP-3666 is set to DHCP. If the DHCP server does not provide an IP address for the AP, you can use the following
settings to access the AP: 192.168.0.50 or type dap3666.local in the web browser's address bar.
y Perform a Ping test to make sure that the DAP-3666 is responding. Go to Start > Run, type cmd, and then press Enter. At the DOS prompt,
type ping 192.168.0.50. A successful ping will show four replies.
Note: If you have changed the default IP address, make sure to ping the correct IP address assigned to the DAP-3666.
D-Link DAP-3666 User Manual 97