Open The Enclosure - Honeywell R5500 Planning, Installation And Service Manual

Chapter 5 - Servicing
To remove the workstation from a Cabinet
1. Open the rear cabinet door.
2. Disconnect the cables that are connected to the back panel connectors of the workstation. Do not
disconnect the peripheral ends of the cables unless specifically instructed to do so. Tag the cables
so that they can be properly reconnected to the workstation.
3. Open the front cabinet door.
4. Remove the captivated panel fastener screws from the threaded inserts.
5. If the retaining brackets are attached, loosen the two captivated fasteners on each retaining bracket
and remove them. The following image illustrates the two captivated fasteners being removed.
6. If you are using a slide mount option, pull the slide try out and place the workstation on a suitable
work surface or you may service the workstation while still on the slide tray.
5.1.3

Open the enclosure

To simplify servicing when using the slide mount option, internal hardware components can be serviced
without having to remove the enclosure from the console or cabinet.
- 40 -