System Parameters Menu - Honeywell Notifier ID3000 Manual

ID3000/ID2000 Fire Panel Configuration Tool Manual
Prints zone Network zones only: if a
descriptions network zone number is no
longer used, highlight the
zone number then select
'Remove' to delete it

1.5.9 System Parameters Menu

Available if a
configuration is
open in the Tool
1 - 18
This menu has the following options:
a. Set Site ID. Displays the Site Setup and
Customer Details window. See next page.
b. Sector Configuration. Opens the ID
network sector configuration window (see
Section 6.3.3 for assigning panels to sectors).
c. Network Setup. Displays the Network Setup
History window (see Section 6.2.2 or 6.3.2 for
Master/Slave network or ID
d. F-CMSI Connection Setup is for use with
the F-NF3000 Panel only.
e. Event Distribution. Applies to ID2000 with
Master/Slave network - displays the Event
Distribution window (see Section 6.2.2).
f. Control Matrix. Displays the Edit CBE
Rules window (see Section 4.2).
g. Select Custom Tone. Applies to ID3000
with OPAL loop protocol only. Define a
sounder tone and volume for advanced
sounders (see Section 3.2.3).
h. Edit Zone Text. Applies to ID3000 only (see
below for further information).
Edit Local Zone Descriptions Window
This window allows direct text entry of the
Zone description (these descriptions can also
be edited on the panel's loop configuration,
see Section 3.2). Remember, entries are
restricted to a maximum of 32 characters.
Network zones: click here to sort
997-291, Version 3.05
2
net
2 net respectively).
November 2010