Table of Contents
Advertisement
4.
If the unit can be safely operated in the U-NII Mid or U-NII
Worldwide frequency ranges in its current location, your
Fluidmesh Networks representative will forward you the
Fluidmesh UNII2 plug-in (part number FM-UNII2) free of charge.
This plug-in unlocks access to these frequency bands.
Every Fluidmesh unit uses a proprietary distributed-channel switching
algorithm. If the UNII2 plug-in is installed, and a TDWR radar transmission
is detected:
• The algorithm will attempt to switch communicating Fluidmesh units
to
the
communications with no radar interference.
• The number of detected radars is reported in the command-line
interface (CLI).
The number of TDWR transmissions detected by the unit is shown in the
command-line interface (CLI), and in
To enable the use of U-NII-2A, U-NII-2C and U-NII-2E frequency bands on
the unit, do the following steps:
1.
Contact your Fluidmesh Networks representative to obtain the the
DFS plug-in (part number FM-UNII2) free of charge.
2.
Install the UNII2 plug-in as shown in
procedures" (page
3.
When you activate the UNII2 plug-in through the Fluidmesh
Partner Portal, you will be prompted to point out the exact
location where the unit will be installed.
• The Partner Portal will verify that there are no TDWR radar
installations within 40 miles (64 Km) of the Fluidmesh unit.
If no TDWR radar installations are found, the plug-in will
grant permission for the unit to be set to frequencies within
the 5.250 GHz-to-5.350 GHz band, and the 5.470 GHz-
to-5.725 GHz band.
• If the unit is already set to an operating frequency that is
within the above frequency bands, a banner will appear in
the Configurator UI, recommending that you contact
Fluidmesh Support to request the FM-UNII2 plug-in, and
verify the location of the unit.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
next
radar-free
channel,
"The device status view" (page
146).
IMPORTANT
Fluidmesh Networks Inc. will not, under any
circumstances, be held liable for any incidental,
consequential or special damages, whether based on
tort, contract, or otherwise, arising out of or in
connection with improper use or operation of the
channel width functionality and/or UNII2 functionality.
allowing
uninterrupted
"Plug-in management
Page 71 of 174
134).
Advertisement
Table of Contents
