Table of Contents
Advertisement
Fluidmesh hardware devices are shipped from the factory with L2TP
functionality disabled. To change the unit's L2TP settings, do the following
steps:
1.
Click the -l2tp configuration link under ADVANCED SETTINGS
in the left-hand settings menu.
Figure 46. Configurator GUI (L2TP Configuration dialog)
• The L2TP Configuration dialog will be shown
(page
2.
To enable L2TP functionality for the unit, check the L2TP check-
box.
• The L2TP configuration settings window will be shown.
3.
When the L2TP configuration has been set, save the settings by
clicking the Save button. Alternatively, clear the settings by
clicking the Reset button.
IMPORTANT
A detailed description of L2TP configuration methods is
beyond the scope of this manual. For detailed instructions on
how to set the L2TP configuration, refer to the Fluidmesh
Networks L2TPv3 Configuration Manual.
7.7.10. VLAN settings
VLAN configuration
The VLAN SETTINGS window contains controls to connect the Cisco
FM4500 Mobi to one or more virtual local area networks (VLANs) that are
part of the local wireless network.
IMPORTANT
The VLAN feature must be enabled using a software plug-in
(Fluidmesh part number FM-VLAN). Contact your Fluidmesh
Networks representative for details.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
114)).
(Figure 46
Page 114 of 174
Advertisement
Table of Contents
