Removing Shield Inserts From The Shield For Sf Breaker Installation - GE A-Series II Panelboard Instructions Manual

Figure 3. Removing the shield inserts from the shield for SF breaker installation in
11. To install branch breaker (kit ASPP6SF3S) on left side of interior, place the filler
plate [11] over the dead front so that the four same-size holes line up with the
threaded holes of the dead front, as illustrated in Figure 4. Fasten filler plate to the
dead front with four #10-32 x
12. To install branch breaker (kit ASPP6SF3S) on right side of interior, flip filler
plate [11] and place it over the dead front so that the four same-size holes line up
with the threaded holes of the dead front, as similar to step 11. Fasten filler plate
to the dead front with four #10-32 x
13. Reattach the dead front to the interior with the 8 screws removed in step 2.
Tighten the screws to 27-36 in-lb.
DEH40151
®
A –Series II Panelboards.
3
/ screws [12] tightened to 27-36 in-lb.
8
3
/ screws [12] tightened to 27-36 in-lb.
8
4
DEH40151
Rev.No.02