Honeywell GENT Xenex Operating Instructions And Log Book page 10

Fire Panels
System configuration record
Record of how the system is configured.
Mark in the table below any deviation(s) from the standard factory settings
Detection and zone circuit configuration
Zone number
Normal zone operation (factory setting)
Non latching zone operation
First fire to be a pulsing indication (factory setting)
First fire to be a steady indication
Zone short circuit to give a fault (factory
setting)
Zone short circuit to give a fire
Sounders and system reset configuration
Silence alarms and reset to operate independently (factory setting)
Silence alarms and reset to operate as per BS5839: Part 4
Reset to also action the silence alarms
Sound alarms to operate in fire condition only ( factory
setting)
Sound alarms to operate at any time
Auxiliary relay to energise with fire (factory setting)
Auxiliary relay to energise with sound alarms
Access level
Cancel buzzer (AL1 - factory setting)
Test A & B mode, Cancel Test (AL2 - factory setting)
Display test (AL1 - factory setting)
Repeat panel information
Repeat panel
1st Repeat panel
2nd Repeat panel
3rd Repeat panel
4th Repeat panel
Delay mode setting:_____________________________minutes
4188-424 issue 8_Part 2_07-14_Xenex
1 2 3
Access levels AL1
N/A
EEPROM EEPROM
location Data (address)
10
System configuration record
.
8 5 6
AL2
Name of the area where the panel
is installed on site
7 8